Vertical Augmentation Using Onlay Versus Inlay Autogenous Graft With Simultaneous Implant Placement.
Bone Resorption
About this trial
This is an interventional treatment trial for Bone Resorption
Eligibility Criteria
Inclusion Criteria:
* Patients with partially edentulous anterior maxillary ridges.
- Patients were free from any systemic disease that interferes with bone healing.
- Absence of local pathosis at anterior maxillary area.
- No history of any grafting procedure at the designated edentulous ridge.
The edentulous ridge vertical dimension was less than 10 mm measured from the alveolar crest to the nasal floor (i.e.ridge had vertical inadequacy) with normal horizontal alveolar dimension or patient with Increased Inter-Arch Space.
Exclusion Criteria:
* Patient with fully dentulous maxilla.
- Pregnant females.
- Presence of bad habits (severe bruxism, clenching).
- Systemic diseases that may interfere with bone healing.e.g. uncontrolled Diabetes.
Sites / Locations
Arms of the Study
Arm 1
Arm 2
Placebo Comparator
Active Comparator
control
Comparator
Crestal pyramidal flap will be done with 2 releasing incisions for adequate exposure. Buccal& palatal full reflection for adequate exposure and to avoid the interference between the onlay graft and the residual bone. Decortication of the bone bed to increase the blood supply to the onlay graft. The block graft harvested from the chin is placed crestal to the residual ridge and stabilized in place using dental implant immediately. Periosteal incisions are usually needed to allow tension free sutures. Vicryl 3/0 sutures for closer. augmentin 1g twice daily for 5 days. catflam 50g twice daily for 3 days
Crestal incision with labial flap reflected leaving the palatal tissues without elevation. Marking of the 3 bony cuts ( 2 vertical cuts & 1 horizontal cut ) using fine fissure bur in the form of perforations along the cuts position. Drilling of pilot drill and first drill only. 3 full thickness cuts will be performed (2 vertical stop cuts will be made by using the tungsten carbide disc at the distal ends of the horizontal bony cut on the facial surface of alveolar ridge. splitting osteotomes are used and mallet to complete the splitting of the bony segment. After bony separation the rectangular bony segment (transport segment) will be mobilized occlusally and pedicled on the palatal mucoperiosteum. The autogenous block graft harvested from the chin area is placed in the space gained under the mobile bony segment. Drilling through the bony segment and the block graft. Immediate implant placement chin graft block dental implants