Transepidermal Application of Metilaminolevulinate in Daylight PDT in the Treatment of Photodamaged Skin
Skin Diseases
About this trial
This is an interventional treatment trial for Skin Diseases
Eligibility Criteria
Inclusion Criteria:
- Both gender;
- Fitzpatrick phototypes I - IV;
- age between 40 and 75 years;
- photodamaged skin with at least 1 lesion of actinic keratosis
Exclusion Criteria:
- Pregnancy and lactation;
- photosensitivity;
- smoking;
- malignant neoplasms;
- infections;
- immunosuppression;
- collagenoses;
- any systemic disease or emotional/psychological disorder that could contraindicate the procedure.
- any topical treatment or interventions for at least three months before the study started
Sites / Locations
- Hospital Universitário Antonio Pedro - Universidade Federal Fluminense
Arms of the Study
Arm 1
Arm 2
Arm 3
Arm 4
Active Comparator
Experimental
Experimental
Experimental
Group I (Standard DL-PDT)
Group II (DL-PDT with microneedles)
Group III (DL-PDT with CO2 laser)
Group IV (DL-PDT with microdermabrasion)
Superficial skin curettage all face with a dermatological curette All exposed skin was covered with pure chemical sunscreen After 15 minutes, a uniform layer of methyl-aminolevulinate (MAL) (Metvix®, Galderma- 1g) was applied to the face without occlusion In all protocols, the patients remained indoor for 30 min after procedures and then exposed to daylight in an open environment for 2 hours. After this period, the skin was cleaned with 0.9% saline, and the sunscreen reapplied.
Superficial skin curettage all face with a dermatological curette All exposed skin was covered with pure chemical sunscreen After 15 minutes, a uniform layer of methyl-aminolevulinate (MAL) (Metvix®, Galderma- 1g) was applied to the face without occlusion A motorized pen with a tip of 17 grouped needles with 0,5mm (Dermapen Beauty®- Korea) was applied without bleeding In all protocols, the patients remained indoor for 30 min after procedures and then exposed to daylight in an open environment for 2 hours. After this period, the skin was cleaned with 0.9% saline, and the sunscreen reapplied.
Superficial skin curettage all face with a dermatological curette All exposed skin was covered with pure chemical sunscreen After 15 minutes and removing excess sunscreen, Ablative Fractional Laser (AFXL), CO2 laser, roller-type ferrule, composed of one row with seven fractionating pins (7x1), 60 W, 15 mJ/pixel, 125μm/pixel, 2 mm spacing between ablation zones, density <1% (Pixel Alma Lasers ®) was applied, single-pass A uniform layer of methyl-aminolevulinate (MAL) (Metvix®, Galderma- 1g) was applied to the face without occlusion In all protocols, the patients remained indoor for 30 min after procedures and then exposed to daylight in an open environment for 2 hours. After this period, the skin was cleaned with 0.9% saline, and the sunscreen reapplied.
Superficial skin curettage all face with a dermatological curette Microdermabrasion with aluminum oxide crystal (Pan Eletronic®) was performed after superficial skin curettage. Three passes on the skin in different directions (vertical, horizontal, and oblique) were applied All exposed skin was covered with pure chemical sunscreen After 15 minutes, a uniform layer of methyl-aminolevulinate (MAL) (Metvix®, Galderma- 1g) was applied to the face without occlusion In all protocols, the patients remained indoor for 30 min after procedures and then exposed to daylight in an open environment for 2 hours. After this period, the skin was cleaned with 0.9% saline, and the sunscreen reapplied.