Semilunar and Conventional Coronally Positioned Flap for the Treatment Gingival Recession
Gingival Recession, Root Coverage
About this trial
This is an interventional treatment trial for Gingival Recession focused on measuring gingival recession, semilunar coronally flap, coronally advanced flap
Eligibility Criteria
Inclusion Criteria:
- Patients are in general good health.
- The patient is non-smoker (less than 10 cigarettes per day) and non-alcoholic.
- Female participants must not be pregnant and not at menstrual period during surgery.
- The patient is committed to the oral care, and has a healthy periodontium.
- Absence of severe oral habits.
- They have not taken medication known to interfere with periodontal tissue health or healing in the preceding 6 months.
- Presence of bilateral buccal Miller class I gingival recessions (≤5 mm) in maxillary incisors, canines, or premolars.
- Presence width of keratinized tissue (WKT) ≥2 mm.
- The tooth is vital and absence of caries or restorations in the areas that will be treated.
- Pocket depth less than 3 mm without bleeding on probing (BOP).
Exclusion Criteria:
- Patients less than 18 years old
- Patients with untreated periodontal disease.
- Smokers.
- Immunosuppressive systemic diseases (like cancer, AIDS, diabetes…)
- Miller's class II, III or IV gingival recession defects.
- Presence of apical radiolucency or root surface restoration or caries at the defect site
- Medications influence on the health of the gingival tissue (like calcium channel blockers, immunosuppressive systemic diseases (like cancer, AIDS, diabetes…) or Long-term steroid use
Sites / Locations
- Department of Periodontics, University of Damascus Dental School
Arms of the Study
Arm 1
Arm 2
Experimental
Active Comparator
semilunar coronally positioned flap
coronally advanced flap
A semilunar incision will be done following the curvature of the gingival margin and ending about 2 to 3 mm short of the tip of the papillae. The most apical distance of this incision to the gingival margin will be obtained by adding the bone sounding measurement to the recession height. Perform a split-thickness dissection coronally from the incision, and connect it to an intrasulcular incision. The tissue will be collapsed coronally, covering the denuded root. The coronally repositioned gingival margin will be stabilized by coronally anchored suture with composite stops on the buccal surface of the tooth using flowable composite. Finally, the area will be covered with a periodontal dressing. This is called semilunar coronally positioned flap.
Coronally positioned flap will be initiated with two vertical incisions, extending from a mesial and distal linear angle at the cementoenamel junction (CEJ) and go beyond the mucogingival junction. A split thickness flap will be prepared by sharp dissection mesial and distal to the recession and connected with an intra crevicular incision. On the facial aspect of the tooth, a full thickness flap, approximately 3-4 mm apical to crest of alveolar bone. Then, the flap will be returned and sutured it at 1 mm coronal to the CEJ after de-epithelize the papillae. The coronally repositioned gingival margin will be stabilized by coronally anchored suture with composite stops on the buccal surface of the tooth using flowable composite and sutured in the papilla region and releasing incision. Finally, the area will be covered with a periodontal dressing.